|
|
|
|
|
|
|
|
|
|
|
| |
Bearing End Break Down- One grease zerk which moves the grease from the inside to the outside
- 2 dust covers with seals
- 2 needle bearings
- hardened and ground to size bearing sleeve
- 2 grease seals
- 2 hardened thrust washers
- Houser 1-piece delrin bushing
- Unsealed dust cover, unless stock dust cover is used
Slicast™ System
- Positive caster is achieved by rotating the ball joint cam towards the rear of the ATV making the ATV handle better in a straight line, but harder to turn
- Negative caster is achieved by rotating the ball joint cam towards the front of the ATV making it corner better, but twitchy in a stright line
Adjusitng the slicast™ is done in 3 easy steps:
- Back off the jam nut in the front of the upper ball joint
- Pull the Slicast™ piece out 1/8" and rotate it to the desired setting that you want to achieve
- Re-tighten the jam nut. Yess it is that quick and simple
|
|
|
|
|
|
|
|
|
